Epson Stylus Pro 7600 - Operating Panel; Buttons and Functions; Functions of Buttons

EPSON Stylus Pro 7600/9600 Revision A
Product Description Operating Panel 31
1.4 Operating Panel
1.4.1 Buttons and Functions
The operating panel contains the following buttons.
Figure 1-7. Panel Design
 Power
 Pause
 SelecType (Panel setting menu shift, setting item shift (down))
 Paper Feed ∆ (setup value +)
 Paper Feed ∇ (setup value -)
 Paper Source (Item shift (up))
 Cut / Eject (Enter)
 Cleaning
1.4.1.1 Functions of Buttons
Table 1-20. Panel Functions
Switch Function (Independent)
Function
(in SelecType mode)
Function
(+PowerOn )
Power Power ON/OFF - -
Pause Pause / ready,
reset (press for 3 seconds)
Leaving SelectType
mode
Maintenance
mode
SelecType
 During printing
Printer status menu shift
 Except above
Panel setting mode shift
Cutter replace menu
(press for 5 seconds)
Selection of SelecType
menu (major
categories)
-
Cut / Eject
 Eject sheet *
1
 Feed roll paper from cutter
mark to cutting position and
cut. (Auto Cut)*
1
 Feed roll paper to the manual
cutting position (cutter
OFF).*1
Confirm and save
setting values
-
Paper Feed
∆ Paper feed (reverse)*
2
(setup value +)
Increase setup value
-
Paper Feed ∇ Paper feed (forward)*
3
(setup value -)
Decrease setup value
-
Paper Source Select paper source Selection of SelecType
items (minor
categories)
-
Cleaning Cleans all heads
(press for 3 seconds)
- -
Paper Source+
Eject+paper feed
- - Maintenance
mode 2
Eject + Paper
feedD + Paper feed
Self-diagnosis
mode
Cleaning + Paper
Source + Eject
--F/W download