48
Pause
(Reset 3 Sec.)
Stops printing temporarily. Press a second time to
resume printing.
Clears print data in the printer memory if pressed and
held for 3 seconds.
When pressed in SelecType mode, the printer returns
to READY status.
SelecType Enters SelecType mode when pressed in READY
status. When pressed in SelecType mode, a desired
menu can be selected.
Paper Source Selects the paper source: Roll Auto Cut, Roll Cutter
Off or Sheet.
When pressed in SelecType mode, a desired item
can be selected from the menu.
Paper Feed
u Feeds paper in reverse. When pressed in SelecType
mode, a desired parameter can be selected from
the selected item. Parameters change in forward
order.
Paper Feed
d Feeds paper forward. When pressed in SelecType
mode, a desired parameter can be selected from
the selected item. Parameters change in reverse
order.
Cut/Eject
(Enter)
When the Sheet light is on:
Ejects the cut sheet.
When the Roll Auto Cut light is on:
Feeds the roll paper before cutting it.
When the Roll Cutter Off light is on:
Feeds the roll paper to the guide on the platen.
When the Roll Cutter Off light is on and the Print Page
Line is on:
Feeds the roll paper and then prints a page line
below the document. See “PAGE LINE”.
Note:
This button is operable during the ink drying process.
When pressed in SelecType mode, it sets the selected
parameter in the selected item as the default value.
If the selected item is for execution only, the item will
be executed.
To Next Page
Loading...
