1-3
Setting Up the Printer | 1-3
Accessories:
2. Insert one of the legs into the base as shown. (The bolt holes line up only
if the leg is matched with the correct base.) Use the included Allen
wrench to fasten the leg with two bolts (H).
HI
KLJ
G
M
G: Allen wrench (1)
H: Bolts (4) for attaching legs to base
I: Bolts (2) for attaching lower bar to legs
J: Collars (2) for attaching lower bar to legs
K: Phillips screws with washers (4) for attaching top support bar to legs
L: Wing screws (2) for attaching printer to stand
M: Washers (2) for attaching printer to stand
H
bolt holes
underside view of base
showing location of bolt holes
Printer Guide.book Page 3 Monday, April 22, 2002 3:02 PM
To Next Page
Loading...
