1-6
1-6 | Setting Up the Printer
5. Take out the foam supports from under the printer.
6. Remove any packing tape. Check these areas:
•
the front cover
•
the ink compartment cover
•
the maintenance tank on the right side
7. Open the front cover. Then unscrew the bolt and remove the bracket
securing the print head. Save the bolt and bracket in case you need to
ship the printer.
8. If you want to set the
printer on a desk, use at
least two people to hold
it as shown. Otherwise
follow the instructions in
the next section to mount
it on the optional stand.
Warning
Two or more people are
required to lift the printer.
Printer Guide.book Page 6 Monday, April 22, 2002 3:02 PM
To Next Page
Loading...
