Epson Stylus Pro 7710 - Page 278

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 278
Confidential
DISASSEMBLING PROCEDURE
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R. (p206)
3. Remove the Maintenance Tank R. (p208)
4. Remove the Right Cover. (p209)
5. Release the two hooks to remove the Tube Stopper, and pull off the Waste Ink
Tube from the drain outlet of the Maintenance Tank.
6. Release the Waste Ink Tubes from the tube retainer.
7. Pull off the Pressure Tube from the main body, and release the Pressure Tube from
the guide.
Figure 4-125. Releasing the FFC, Waste Ink Tube and Pressure Tube
Clamp
Hole
- Rear right -
Tube retainer
Pressure Tube
Guide
Hooks
Tube Stopper
Waste Ink Tubes
FFC