1-19
Setting Up the Printer | 19
2. Insert the right leg into the right base as shown. (Note that the bases are
labeled
L and R.) Use the included hex wrench to fasten the leg with the
two base bolts.
3. Assemble the left leg and base in the same way.
4. Attach the bottom horizontal strut as shown, then fasten it with one
collar and one strut bolt at each end. Make sure the bolts are tight.
Note: Make sure you
tighten all bolts before
moving to the next
section.
Bolt holes
Underside view of base
showing location of bolt holes
Collar
Strut bolt
7800-9800Guide.book Page 19 Monday, April 10, 2006 11:59 AM
To Next Page
Loading...
