1-37
Setting Up the Printer | 37
Connecting the Power Cord
1. Connect the power cord to the AC inlet on the back of the printer.
2. Route the power cord through one of the hooks on the left or right side
as shown.
3. Plug the power cord into a properly grounded electrical outlet.
Note: The illustrations in
this section and the
following sections show
the Epson Stylus Pro
9800, but the instructions
are the same for the
7800.
Caution: Do not use an
outlet that is controlled
by an automatic timer or
wall switch. Otherwise,
you may accidentally shut
off the printer and cause
damage.
7800-9800Guide.book Page 37 Monday, April 10, 2006 11:59 AM
To Next Page
Loading...
