199
Installing and Using Optional Equipment | 199
7. To remove your prints, turn the lever to unlock the reel, and then slide it
left. Support the reel with one hand to keep it from falling.
8. Remove the take-up reel core from the paper stop on both ends of the
reel.
Adjusting the Auto Take-Up Reel Sensor
If the Sensor light on the Auto Take-Up Reel is flashing, you need to adjust
the sensor position.
1. Loosen the knob on the light emitter as shown below.
Caution: Avoid placing
the sensor in direct
sunlight and prevent fans
or air conditioners from
blowing directly on the roll
paper; otherwise, the auto
take-up reel may not
operate properly.
To Next Page
Loading...
