Setting Up Your System for Network Printing 15
The following table lists the components required for network printing.
4. If the necessary components are not in the list, click Install to install them.
5. For LPR printing:
Double-click Internet Protocol (TCP/IP) on the Local Area Connection
Properties dialog box to open the Internet Protocols (TCP/IP) Properties
dialog box. Set the IP address, the subnet mask, etc., and then click OK.
6. Restart the computer.
The necessary components are now installed. Go to the section “Connecting
the Network Printer to the Network” on page 16.
Mac OS X
To assign an IP address, subnet mask, etc. to your Macintosh, follow the
steps below.
1. From the Apple menu, select System Preferences.
2. Open the Network control panel.
3. Select Ethernet as the connecting method on the Network control panel,
select the method to assign the IP address from the Configure menu, and
then assign the IP address.
4. Click the Apply or Apply Now button to save any changes.
Go to the section “Connecting the Network Printer to the Network” on page 16.
Printing method Necessary components
LPR printing Internet Protocol (TCP/IP)
To Next Page
Loading...
