Epson Stylus Pro 7890 - Page 70

Epson Stylus Pro 9890/9908/7890/7908 User’s Guide
Maintenance
70
E
Push the expended cartridge so the
cartridge is slightly pushed out.
F
Carefully pull the expended cartridge
straight out of the slot.
G
Remove the new cartridge from the
package, shake the ink cartridge at least 15
times horizontally in approximately 5 cm
movements as shown in the illustration.
H
Hold the ink cartridge with the arrow mark
facing up and pointing to the rear of the
printer, and then insert it into the slot as far
as it will go until it clicks.
Match the ink cartridge color with the color
label on the back side of the ink cover.
I
Close the ink cover.
w
Warning:
If ink gets on your hands, wash them
thoroughly with soap and water. If ink
gets into your eyes, flush them
immediately with water.
c
Caution:
Do not touch the green chip on the side of
the cartridge. Doing so may prevent
normal operation and printing.
Note:
Be sure to install all nine ink cartridges. You
cannot print if any of the ink cartridges is not
installed.