Epson Stylus Pro 9000 - Cleaning the Printer

EPSON Stylus Pro 9000 Revision B
Adjustment Adjustment Steps 114
5.2.3.2 Self-Diagnostic Mode Menus
In the Self-Diagnostic mode, you can select from the following menus.
Figure 5-2. Self-Diagnostic Menu Flow
Table 5-4. Self-Diagnostic Menus
Message Description
Check: Test Verifies certain information such as RAM, version number,
panel, sensors, fatal-error history and encoder.
Check: Adjustment Adjusts certain mechanism such as printheads, sensors,
and feed path.
Check: Cleaning Starts initial ink charge or predetermined cleaning sequence
Check: Print Prints nozzle check pattern or adjustment parameter list
Check: Parameter Updates or clears all of the adjustment parameters
Check: Life Tests the operation of the printer components.
CAUTION
n The "Check: Life" menu contains tests that should
only be performed at the factory, so do not attempt to
use this menu.
n In Self-Diagnostic mode, all of the tests except for
one (Rear Sensor adjustment) assume that you have
loaded roll paper. Even if you load single sheets, the
printer handles the paper as if it were roll paper.
n All explanations in this mode refer to the printheads
in the following way:
B head = K/C/M side (left side facing the printer)
C head = Lc/Lm/Y side (right side facing the printer)
Check: Adjustment
Check: Test
Check: Print
Check: Cleaning
Check: Parameter
[SelecType]
[Paper Source]
[Enter]
[Pause]
Another
kind of
menu
Check: Life