Epson Stylus Pro 9000 - Page 84

EPSON Stylus Pro 9000 Revision B
Disassembly & Assembly Disassembly Flow 84
6. Remove the following screws that secure the L/R Waste Ink Boxes, and
then remove the L/R Waste Ink Boxes.
- Waste Ink Box L: One CP(W2) M4x8 screw
- Waste Ink Box R: Two CP(W2) M4x8 screws
Figure 4-17. Waste Ink Box R
Figure 4-18. Waste Ink Box L
7. Remove the old Waste Ink Pads from inside both of the Waste Ink Boxes.
8. Insert new Waste Ink Pads in the Waste Ink Boxes, and re-install the
Waste Ink Boxes in the printer.
CP(W2) M4x8 screws
WasteInkBoxR
CHECK
PO INT
When replacing the Waste Ink Pads, prepare a vinyl bag
beforehand for disposing the Pads.
ADJUSTMENT
REQUIRED
When replacing the Waste Ink Pads, the following
adjustment procedures are required.
n INIT. WASTE INK
n INIT. CLEANER
n Cutter Position
WasteInkBoxL
CP(W2) M4x8