Epson STYLUS PRO 9400 - Page 103

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 103
HEX DUMP
Print data received by the printer is printed out in hexadecimal notation. Using this
function, users can check that data has been sent correctly from the computer to the
printer.
On the printout, 16 bytes of print data in hexadecimal are indicated on the left followed
by the corresponding ASCII characters. If the hex number has no corresponding ASCII
characters, such as control code, “.” (period) is indicated instead of ASCII characters.
The data is output (printed) in a 16-byte unit. If the last data is less than 16 bytes, it is
not printed unless you press the [Pause] button.
Panel setting is not available in the hex dump mode.
To terminate the mode, stop printing by pressing [Pause] button and shut the power off.
LANGUAGE
The user interface language can be selected from English, French, Italian, German,
Spanish, Portuguese and Dutch.
REMAINING PPR SETUP
Enables or disables the roll paper remaining amount detection function.
OFF: Disables the detection function.
The ROLL PAPER COUNTER of the PRINTER SETUP menu in the Panel
Setting mode disappears.
ROLL: Enables the function.
The ROLL PAPER COUNTER of the PRINTER SETUP menu appears and
the roll paper remaining amount can be checked there.
UNIT
Switches the unit of length used in the panel display and pattern printing between meter
and feet/inch.
 METER: Meter (m)
 FEET/INCH: Feet (ft)/Inches (in)
The table below lists the items to which the unit change is reflected.
CUT PRESSURE
The default Cut Pressure is set as 100% at the factory. It can be changed in the range of
0 through 150%. The percentage is referred to as the absolute level for the printer, so
the Cut Pressure values specified in the following items are multiplied by the
percentage.
 Remote command SN m1=81h
 CUSTOM PAPER (Panel Setting mode)
Table 1-51. Reflection of the Unit of Length Change
Item
Message
Meter Feet/Inch
Panel LCD Display Roll paper remaining value xxm xxxft
Roll paper length xx.xm xxxft
Roll paper length warning xxm xxft
Paper counter xxxxx.xcm xxxxft xxin
Job information display
(Paper used amount)
xxxxxxxcm
2
xxxxxx.xsqft
Nozzle Check Pattern Current Paper Count xxxxx.xcm xxxxft xxin
Prev Paper Count xxxxx.xcm xxxxft xxin
Status Sheet Use Paper xxxxxx.xcm xxxxft xxin
Job Information Print Paper used (Vertical) xxxxxx.xcm xxxxft xxin
Paper used (Horizontal) xxxxxx.xcm xxxxft xxin