Epson STYLUS PRO 9400 - Page 217

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 217
4.2.2.2 Maintenance Tank
1. Pull out the Maintenance Tank while holding the printer, and remove the tank
putting your other hand on it not to tilt it.
Figure 4-9. Removing the Maintenance Tank
C A U T I O N
When removing the Maintenance Tank in the next step, be sure not
to touch the IC chip on the tank. Doing so may cause a malfunction
of the printer.
C H E C K
P O I N T
The Stylus Pro 9400/9800 have two Maintenance Tanks, and the
7400/7800 have one tank on its right side.
IC Chip
Maintenance
Tank