Epson STYLUS PRO 9400 - Page 218

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 218
4.2.2.3 Cutter
1. After turning the printer ON, press and hold the Paper Source button for 3
seconds or more to put the printer into the cutter replacement mode.
2. The CARRIAGE ASSY. will move to the cutter replacement position.
3. Open the FRONT COVER ASSY.
4. Press down the boss on the Cutter lightly and turn the Cutter Cap clockwise. See
Figure 4-10.
5. Remove the Cutter from the CARRIAGE ASSY. See Figure 4-11.
Figure 4-10. Removing the Cutter (1)
Figure 4-11. Removing the Cutter (2)
C A U T I O N
Beware of the following items when performing the next step.
 Push the boss on the Cutter lightly. Do not push it too much as
the blade edge may damage the printer’s internal components.
 The Cutter may pop up if you push the Cutter too much and
release it suddenly as a spring is incorporated into the Cutter.
Be careful not to do that.
 Be careful not to drop the Cutter or hit it against hard object
such as metal parts, or the cutter blade may chip.
4-1
4-2
Cutter Cap
Cutter