Epson STYLUS PRO 9400 - Page 248

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 248
4.2.5.6 CUTTER SOLENOID ASSY.
1. Disconnect the connector of the CUTTER SOLENOID ASSY. from the BOARD
ASSY, SUB. See Section 4.2.4.4 on page 236.
2. Pull out the harness of the CUTTER SOLENOID ASSY. through the notch of the
CR BOARD HOLDER. See Figure 4-67.
3. Remove the CR ENCODER HOLDER. See Section 4.2.5.5 on page 246.
4. Cut the TILAP and release the harness, FFC, and the grounding wire. See Figure
4-68.
5. Remove the three screws that secure the CUTTER HOLDER ASSY. and remove
it. See Figure 4-68.
 Three C.P.S.(S-P2) M3 x 5 screws
Figure 4-67. Pulling Out the CUTTER SOLENOID ASSY. Harness
Figure 4-68. Removing the CUTTER HOLDER ASSY.
Secure the following harnesses, FFCs, and the grounding wire with
a TILAP at the position shown in the figure. See Figure 4-68.
 CUTTER SOLENOID ASSY. harness
 P Edge Sensor harness
 CR Encoder Sensor FFC
 IM Sensor FFC
 Grounding wire (connected between the BOARD ASSY, SUB
and the CARRIAGE ASSY.)
Set the two positioning holes of the CUTTER HOLDER ASSY. onto
the two guide pins. See Figure 4-68.
CUTTER SOLENOID
ASSY. harness
CR BOARD HOLDER
Notch
C.P.S.(S-P2) 3x5
Guide Pin
Guide Pin
TILAP
CUTTER HOLDER ASSY.