Epson STYLUS PRO 9400 - Page 257

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 257
9. Remove the three screws that secure the PF MOTOR ASSY. and remove it. See
Figure 4-87.
 Three C.P.S.(S-P2) M4 x 8 screws
Figure 4-87. Removing the PF MOTOR ASSY.
Reinstall the PF MOTOR ASSY. so that the harness outlet of the
assy. faces toward the rear side of the printer. See Figure 4-87.
A D J U S T M E N T
R E Q U I R E D
Whenever the PF MOTOR ASSY. is reinstalled or replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
C.P.S.(S-P2) 4x8
PF MOTOR ASSY.
Harness Outlet