EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 283
12. Loosen the four screws that secure the four TUBE, SUPPLY, INK, and remove
them from the HOLDER ASSY., IC, LEFT.
Four Coupling Screws
Figure 4-134. Removing the HOLDER ASSY., IC, LEFT (2)
C A U T I O N
Beware of the following items when performing the next step.
As remaining ink may leak or spatter, have a waste cloth
beforehand to wipe out it.
Exercise care to avoid letting the dust or any foreign materials
get inside the TUBE, SUPPLY, INK.
Make sure that the O-RING is attached to the leading end of
each one of the four TUBE, SUPPLY, INK.
Figure 4-133. Reinstalling the TUBE, SUPPLY, INK
A D J U S T M E N T
R E Q U I R E D
Whenever the HOLDER ASSY., IC, LEFT is reinstalled or
replaced, the corresponding adjustment must be carried out. See
Chapter 5 on page 292.
O-RING
Coupling Screws
To Next Page
Loading...
