Epson STYLUS PRO 9400 - Page 284

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 284
4.2.7.4 PUMP CAP ASSY.
1. Remove the R SIDE COVER ASSY. See Section 4.2.3.4 on page 223.
2. Release the harnesses of the Pump Motor from the retaining clip.
3. Disconnect the Pump Motor connector from the relay connector.
4. Pull the Waste Ink Tubes out of the Ink Exhaust.
5. Release the two locks of each of the two retaining clips with locks that secure the
Pump Motor harnesses and the Waste Ink Tubes and release them from the clips.
Figure 4-135. Releasing the Pump Motor Harnesses and Waste Ink Tubes
C A U T I O N
When removing the PUMP CAP ASSY., ink may leak out of the
Waste Ink Tubes and the Ink Exhaust. Have a waste cloth
beforehand to clean up.
C A U T I O N
When reinstalling the Waste Ink Tube, make sure to insert it
correctly into the waste ink outlet and route the tubes as shown in
the figure right, or ink may leak.
Retaining Clip
Waste Ink Tubes
Retaining Clips
With Locks
Ink Exhaust
Locks
Pump Motor
Harnesses
Relay Connector
Right Rear of the Printer