Epson STYLUS PRO 9400 - Page 61

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 61
1.4.4.3 Roll Paper Counter
This menu appears when REMAINING PPR SETUP in the Maintenance mode has been set to
ROLL. The menu allows you to specify the length of roll paper within the range from 15 ft. (5.0
m) to 300 ft. (99.5 m) in increments of 1 ft. (0.5 m)
using the [Paper Feed ( ) ] buttons.
If you hold down one of the buttons for two seconds, the length is increased or
decreased in 10 ft. (10 m) increments.
Roll Paper Counter Menu
 Setting the Length of Roll Paper
Note 1: If the unit is changed, the roll paper length setting and the Roll Paper Counter are reset
to their default.
 Setting the Warning Length of Roll Paper
When the Roll Paper length is set, an asterisk (*) is displayed beside the set
value for two seconds and then the Roll Length Alert screen appears. The alert
menu allows you to set a length to be informed as a warning when remaining
length of roll paper becomes the set value. It can be set within the range from
3 ft. (15 m) to 50 ft. (15 m) in 1 ft. (1 m) increments.
When the alert setting is accepted, an asterisk (*) appears beside the set value
for two seconds and then the screen returns to the Printer Setup menu screen.
Note 1: If the unit is changed, the roll paper length setting and the Roll Paper Counter are reset
to their default.
Setting
Setting
Setting
Setting
Setting
PRINTER SETUP
ROLL PAPER COUNTER
PLATEN GAP
PAGE LINE
ROLL PAPER LENGTH
---
ROLL PAPER LENGTH
5.0m
ROLL PAPER LENGTH
99.5m
ROLL PAPER LENGTH
99.0m
ROLL PAPER LENGTH
20.0m
Setting
Setting
Setting
Setting
ROLL LENGTH ALERT
1m
ROLL LENGTH ALERT
15m
ROLL LENGTH ALERT
14m
ROLL LENGTH ALERT
2m
PRINTER SETUP
ROLL PAPER COUNTER
PLATEN GAP
PAGE LINE