Epson STYLUS PRO 9400 - Page 65

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 65
1.4.4.7 Code Page
The Code Page for the printer can be switched between PC437 (extended graphics) and
PC850 (multilingual).
 Code Page menu
1.4.4.8 Roll Paper Margin
Margin setting for roll paper can be selected from the following settings:
 DEFAULT: Left/Right=3 mm. Top and bottom are
depends on media type
 TOP/BOTTOM 15 mm: Left/Right=3 mm, Top/Bottom=15 mm
 TOP 35/BOTTOM 15 mm: Left/Right=3 mm, Top=35 mm, Bottom=15 mm
 15 mm: 15 mm for all four sides.
 3 mm: 3 mm for all four sides.
Note that the margins specified by this setting are created without reducing or
enlarging image size.
 When “3 mm” is selected
Vertical and horizontal page lines are printed along the specified page size.
 When “15mm”, or “Top/Bottom15mm” is selected
Vertical and horizontal page lines are printed along a line 12 mm outside of all
four edges or top and bottom edges of the specified page size.
See “Fig 1-10 Roll Paper Margin (1)” (p.65).
 When “TOP 35/BOTTOM 15 mm” is selected
Vertical and horizontal page lines are printed along a line 12 mm outside of
the top edge of the specified page size.
See “Fig 1-10 Roll Paper Margin (1)” (p.65).
Figure 1-10. Roll Paper Margin (1)
Setting
Setting
PRINTER SETUP
INTERFACE
CODE PAGE
ROLL PAPER MARGIN
CODE PAGE
PC437
PC850
CODE PAGE
PC437
PC850
Roll Paper Width X
Printable Area
X *
X
X
X
Vertical
Line
Cut Position or Border