Epson STYLUS PRO 9400 - Page 87

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 87

Service Life Menu
1.4.4.31 Custom Paper
This function allows the user to store the user-defined paper settings up to 10. Once the
paper setting is made, the user can retrieve the setting just by specifying the assigned
number. The user can refer to, save, delete or set the Custom Paper also by the
“EPSON Service Utility”.
 Setting Method
1. Enter the Custom Paper menu in the panel setting mode.
2. Select a number for the paper setting. (Standard, 1 - 10)
3. Select the PG (Platen Gap).
4. Print the paper thickness detection pattern
(It is not printed when the “Standard” is selected.)
5. Check the printed patterns and select the number of the pattern with the least
displacement.
6. Select the cutting method.
7. Enter paper feed adjustment value.
8. Enter the ink drying time for each pass.
9. Select the paper suction.
10. Select the MW (Micro Wave) print quality setting.
NOTE • In despite of paper number, it is possible to set paper related setting
independently.
• For details of the pattern, see “Paper thickness detection pattern (p.92)”.
• When “STD” is selected for paper number, above 3.-10. are not displayed
and cannot be set.
• “PRINTING” is displayed during printing the detection pattern.
• The default display for paper thickness number selection is the number
corresponding to paper thickness when gap adjustment is performed.
• The Platen Gap may be automatically set to Wider or Standard depends on
the result of detection by the paper thickness sensor.
SERVICE LIFE
CUTTER
E*****F
SERVICE LIFE
CR MOTOR
E*****F
SERVICE LIFE
PF MOTOR
E*****F
SERVICE LIFE
HEAD UNIT
E*****F
SERVICE LIFE
CLEANING UNIT
E*****F
SERVICE LIFE
PRESSURE MOTOR
E*****F
PRINTER STATUS
JOB HISTORY
TOTAL PRINTS
SERVICE LIFE