Epson Stylus Pro 9500 - Conversion Kit

EPSON Stylus Pro 9500 Revision A
Disassembly & Assembly Disassembly Flow 122
4.2.4 Conversion Kit
4.2.4.1 Conversion Kit Component Parts
This kit is a kit which upgrades the Stylus Pro 9000 from a printer that uses
dye-based inks to one which uses pigment-based inks, and is configured from
the following parts.
The parts code for the Conversion kit is different each market as following table
because the document pack is different each market.
NOTE: The document pack is not packed in the Conversion kit for EAI,
EIB, EIS, EFS, EDG in our manufactory. These subsidiaries must
pack your document pack for each pigment product in your
warehouse yourself before you use this conversion kit.
NOTE: A PC card or CD-ROM with the latest firmware written to it is not
packed with this kit, so when implementing the upgrade service, a
PC card or CD-ROM with the latest firmware written to it should be
brought together with this kit.
NOTE: This kit does not include a CPS Soft Ripper or Postscript Server
system disc, so a system disk or materials which are compatible
with the customer’s use environment should be brought together
with this kit.
4.2.4.2 Required Adjustment Item
In the upgrade service, if the necessary parts are assembled, the necessary
adjustment items are as shown below.
Table 4-5. Conversion Kit Component Parts
Part Name Quantity
• Maintenance Kit: 1 Kit
• MC Thick Mat Paper roll 44” x 5 m
• Document Pack
• Damper Assembly
• O-rings
• Joint Screws M6
• Ink Cartridge Model No. Labels
• EPSON _COLOR FAST Label
• Manual Cutter Cut Position Label
• Ink Cartridges
• Transport Liquid S46 Cartridges
•
1 Kit
•1 Roll
•1 Kit
•6 pcs.
•6 pcs.
•6 screws
• 2 labels
• 1 label
• 1 label
• 6 cartridges
• 6 cartridges
Table 4-6. Conversion kit parts code
Market Parts Code Document pack
ETT 1059326 packed
ECC 1059325 packed
Other 1059327 packed
EAI, EIB,EIS, EFS, EDG, 1058466 Not packed
Table 4-7. Adjustment Items
No Adjustment Items
1 Paper guide L installation position adjustment
2 Cutter mounting position adjustment
3 CR cover height adjustment
4 Paper cutting position adjustment
5 Bi-d Adjustment
6 Head GAP adjustment
7 P-EDGE / FRONT / REAR sensor adjustment