EPSON Stylus Pro 9500 Revision A
Adjustment Summary 156
5.1 Summary
This section describes the adjustment procedures necessary after replacing
certain parts and explains how to perform those adjustment procedures.
5.1.1 Caution
Before beginning any adjustment procedure, make sure of the following.
5.1.2 Adjustment Tools
The necessary tools for performing adjustment procedures on this printer are
shown below. .
CAUTION
n Before starting any adjustment procedure, find the
adjustment procedure you need to perform in
Table 5-2 on page 158 and verify the order or the
tasks you need to perform.
n When performing an adjustment procedure, double-
check the detailed instructions and caution
information for that procedure; otherwise you may
damage the printer.
n When replacing the following, always install a new
ink cartridge.
• Printheads
• Main Board
• "Holder, Assembly, Valve"
Table 5-1. Adjustment Tools
Name Part Code Notes
Tension Gauge B747700300/
standard tool
acceptable
Max. 4000g
Tension Gauge
#F712
1047744/ standard
tool acceptable
Max. 200g
Straight edge/ruler
1000mm #F713
1047746/ standard
tool acceptable
Length: 1000mm
Scale Stopper
#714
1047745/ standard
tool acceptable
Used in combination with #F713
(0.1mm scale)
Paper Guide L
Installation Position
Adjustment tool
#F755
Exclusive Part
ASP Code: 1059434
Material: Plastic
Color White
Cutter Installation
Position Adjustment
tool #F759
Exclusive Part
ASP Code: 1059443
Material: Plastic
Color: White
CR Cover-Position
Adjustment Tool
#F724
Special Tool
1049975
Material: Plastic
Color: White
CR ENC Installation
Adjustment tool
#F766
Exclusive Part
ASP Code: 1060655
Material: Plastic
Color: White
PF ENC Installation
Adjustment tool
#764
Exclusive Part
ASP Code: 1060658
Material: Plastic
Color White
PF ENC Installation
Adjustment tool 2
#765
Exclusive Part
ASP Code: 1060657
Material: Plastic
Color: White
Front Cover
Positioning tool
#F754
Exclusive Part
ASP Code: 1059420
Material: Plastic
Color White
To Next Page
Loading...
