EPSON Stylus Pro 9500 Revision A
Adjustment Summary 158
5.1.3 Adjustment Items
All parts that require adjustment when being replaced are listed in the table
below. You will also find a list of required adjustment procedures along with the
order of those procedures.
Table 5-2. Service Parts & Required Adjustments
Service
Operation
Step
Number
Adjustment Items Refer to
Printhead
replacement
1
2
3
4
5
6
7
8
9
10
11
12
<Start the Self-Diagnostic Function>
o Capping position adjustment
o Head rank input (and initial ink
charge)
o Head nozzle check
o Head slant adjustment (B/C heads)
o Head Height (Linear) adjustment
o Bi-D adjustment
o Head Gap adjustment
o Test print
<Head Unit Life Counter Reset>
<Cutter Installation Position
Adjustment>
<CR Cover Height Adjustment>
<Paper Cutting Position Check>
page 170
page 171
page 172
page 173
page 175
page 177
page 180
page 198
page 201
page 205
page 208
page 207
Main Board
replacement
<Caution>
If it is possible to
implement the
adjustment
sequence in the
table at right, it is
not necessary to
perform any
adjustments after
item 4.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
<Parameter Backup / Download>
<DIP-SW Setting>
<Firmware Reload>
<Self-Diagnostic Function>
o Sensor Adjustment
o Capping position adjustment
o Head rank input (initial ink charge
not necessary)
o Bi-D adjustment
o Head Gap adjustment
o Flush point adjustment (L/R)
o Feed adjustment
o Top/bottom adjustment
o Rear Sensor position adjustment
o Test print
<Replace the Waste Ink Pads and clear
the counter>
page 162
page 218
page 164
page 192
page 170
page 171
page 177
page 180
page 182
page 183
page 184
page 198
page 201
To Next Page
Loading...
