Epson Stylus Pro 9500 - Page 205

EPSON Stylus Pro 9500 Revision A
Adjustment Adjustment Steps 205
CUTTER POSITION ADJUSTMENT
This adjustment is performed for the following purposes.
n To assemble the cutter assembly so that it is parallel to the cutter
groove position on the sub-platen on paper guide L.
n To assemble the cutter assembly in the correct position with respect to
the cutter groove position on the sub-platen on paper guide L.
NOTE:The paper guide L installation position adjustment should be
performed before this adjustment is performed.
1. Take out the 2 screws holding the CR Cover, then remove the CR cover.
2. Insert the projections on tool # 759 in the row of holes in the 2nd level of
the sub-platen on the right side of the sub-platen, installing the tool.
Figure 5-16. Setting tool #F759.
3. Move the CR unit so as to cover tool No. #F759, set on the sub-platen. At
this time, the rib on the tool should pass between the cutter assembly and
solenoid.
4. Loosen the 2 screws holding the cutter solenoid and cutter assembly, then
push the cutter assembly to the rib on the tool.
Figure 5-17. Cutter Position Adjustment
5. Tighten the 2 screws holding the cutter solenoid and cutter assembly.
6. Tighten the 2 screws holding the CR cover and assemble the CR cover.
tool #F759
Insert the tool’s projections in
the row of holes on the 2nd level
of the sub-platen. However,
install it on the right end of the
sub-platen as shown in the
above figure.
CHECK
PO INT
n The projections on tool No. #F759 should be inserted
securely in the row of holes on the 2nd level of the
sub-platen.
n The three notches in tool No. #F759 should fit the
ribs on the sub-platen.
Solenoid Assembly
Rib on tool
Cutter Assembly
Cutter and Solenoid
Assembly Installation
Screws, 2 pcs.
(Unit right side.)