Epson Stylus Pro 9500 - Page 29

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 29
PRINTER SETTING MENU
Notes:
1) The setting values in the above table with underlines are default setting values.
2) In the “Roll Paper Margins” setting, if “Vertical 15 mm” (15 mm is set at the top and bottom, and
3 mm is set at the left and right), or “15 mm” (15 mm is set at the top, bottom, left and right), the
printing position of vertical lines and horizontal lines in the portion where 15 mm is set at a
position 12 mm wider than the logical paper (the minimum margin is an area of 3 mm from the
paper edge). (Therefore, the margin becomes 3 mm + 12 mm = 15 mm.) Also, if the printable
area becomes X = 15 mm or greater from the right edge of the paper, that portion is not printed
on.
3) If the “Paper Skew Error Sensing” setting is turned OFF, even if the paper is skewed as it is
being fed, printing will continue, and even if the printed image spills over the edge of the paper
due to skewing, the printer will not give notice of the error, so the user should take full
responsibility for the possible consequences of this setting.
4) If the “Paper Width Sensor” setting is turned OFF, even if the paper is sensed to be in an
abnormal state, printing can be continued, but in that case, the paper width is decided and
printing continued based on the following standards.
• The paper’s left edge position is made the guide mark position on the paper guide.
• The printable area is the printable area specified in the command.
If the “Paper Width Sensor” setting is turned OFF, if printing is being done on a paper which has
a particularly low reflection rate and cannot be detected by the photosensor, this setting is used.
Through the “Paper Width Sensor” OFF setting, if an image which is larger than the set paper is
printed, printing may be done on the platen, so the user must take the responsibility for the
possible consequences. However, if detection of the top edge of the paper fails, it results in an
error.
Table 1-21. SelecType Menu
Display Message Item Notes
PLATEN GAP
AUTO
WIDE
Adjusts the PG width. (Normally used in
Auto.)
For details concerning the PG setting
value, see the Operation Theory section.
PAGE LINE
ON
OFF
When Auto Cut Off is selected on the
control panel, this setting determines
whether a line for manual cutting is
printed.
INTERFACE
AUTO
PARALLEL
MAC
OPTION
Determines which interface the printer
checks for data. Auto continuously checks
all interfaces and is good for normal use.
PARA I/F
COMFAT
ECP
Determines the data transfer rate when
using this interface.(Normally, leave set to
Compatibility.)
CODE PAGE
PC437
PC850
Character code setting. (PC437:
expanded graphics/PC850: multi-lingual)
ROLL MARG
T/B 15mm
15mm
3mm
Sets the margin for roll paper. (disabled for
cut sheet paper)
Vertical 15 mm: A margin of 15 mm is
provided on the left and right of the printed
portion, and a margin of 3 mm is provided
at the top and bottom / 3 mm: A margin of
3 mm is provided at the top, bottom, left
and right. / 15 mm: A margin of 15 mm is
provided at the top, bottom, left and right.
INIT.PANEL EXEC. Initialize control panel setup values
PAPER ALIGN
CHK
( Note 3)
ON
OFF
Turns the paper feed skew detection
setting ON / OFF. For details, see the
Operation Theory section.
PAPER WIDTH
DETECTION
ON
OFF
Turns the paper feed paper width
detection ON / Off. For details, see the
Operation Theory section.