EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 30
TEST PRINT MENU
Test Print Menu
In the test print menu, the test printing shown in the following table can be
done. Each test is set by operating the following panel buttons. When each test
printing operation is completed, the printer returns automatically to the print
ready state.
o Test print menu selection: See the panel setting menu procedure.
o Test Print item selection: “Paper Source” Button
o Set print execution: “Enter” Button
In nozzle check pattern printing, the following data are printed. The printing
size is approximately 9 cm (W) x approximately 3 cm (H).
o Nozzle Check Pattern
o Firmware Version (V0xxxx)
o Waste Ink Counter (xx%) (Waste ink counter remaining capacity %)
Figure 1-5. Nozzle Check Pattern Printing Results
In status sheet printing, the following data are printed. The printing size is
approximately 10 cm (W) x approximately 13 cm (H).
o Printer ID (= Head ID xx - xx - xx - xx - xx - xx)
In xx, the parameters stored in NVRAM are printed out in decimal
numbers.
o The order, from the left to right, is K - C - M - Y - Lc - Lm.
o Type B Interface Connection Condition
o The following printer settings
Head Gap, Border Line (perforation line), Interface (receiving settings),
Parallel Interface (Receiving Speed), Code Page, Version (Firmware
version), Each Ink Life, Cutter Life, Page Count (total printed sheets
count), Ink Pad (Waste Ink Life), CR Motor (CR Motor Life), PF Motor (PF
Motor Life), Head (Head Life), Cleaner (Cleaning Unit Life).
Figure 1-6. Status printing result
Table 1-22. Printer Status Menu
Display message Meaning
VERSION Shows the firmware version.
INK LEFT-C Shows the amount of remaining ink - Cyan
INK LEFT-M Shows the amount of remaining ink - Magenta
INK LEFT-LC Shows the amount of remaining ink - Light Cyan
INK LEFT-LM Shows the amount of remaining ink - Light Magenta
INK LEFT-Y Shows the amount of remaining ink - Yellow
INK LEFT-K Shows the amount of remaining ink - Black
To Next Page
Loading...
