Epson Stylus Pro 9500 - Page 33

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 33
GAP ADJUSTMENT MENU (BI-D ADJUSTMENT MENU)
The paper thickness setting, Bi-D, gap (adjustment of the Bi-d deviation
between the left and right heads), and printing of the adjustment pattern as well
as adjustment are executed in the gap adjustment menu.
Each setting is made by operating the following panel buttons. If you select the
Gap Adjustment Menu, you cannot proceed to selection of the other items
without performing the “Paper Thickness” setting. After setting the paper
thickness (using the Set button), the menu automatically changes to the
adjustment mode.
o Gap Adjustment Menu Selection See the panel setting menu
procedure.
o Item Selection “Paper Source” button
o Changing or Selecting Setting Values “+” or “–” button.
o Setting the Set Value “Enter” button
o Mode End “Pause” button
Note 1) Values with underlines show default values.
Table 1-26. Gap Adjustment Menu
Display Setting Value Contents
PAPER
THICK
Standard
or
0.0 ~ 1.6 mm
Specify the paper thickness used in the gap
adjustment in 0.1 mm units. Ordinarily, the printer is
used with the “Standard” specification, and in this case,
the paper thickness becomes as follows: Paper
Thickness Detection Sensor detection results = If [ON /
Thin Paper] : 0.2 mmIf [OFF / Thick Paper] : 1.2 mm
ADJUST.
PATT.
Print All
#1-#6
Specifies the gap adjustment pattern to be printed. (All
patterns or the desired pattern.)
#1 1-7-15 Bi-D Adjustment (240 cps, Normal dot, Left)
#2 1-7-15 Bi-D Adjustment (240 cps, Normal dot, Right)
#3 1-7-15 Bi-D Adjustment (240 cps, Normal dot, Left)
#4 1-7-15 Bi-D Adjustment (240 cps, Normal dot, Right)
#5 1-7-15 Gap Adjustment 1 (240 cps, Normal dot)
#6 1-7-15 Gap Adjustment 3 (333 cps, Normal dot)