Epson Stylus Pro 9500 - Service Errors

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 35
1.3.4 Service Errors
When “Service Req nnnnnnnn” appears on the LCD display, a fatal error
requiring a service technician has occurred. The nnnnnnnn indicates what
needs to be fixed to return the printer to a working state.
Note 1) The following parts should be replaced and the relevant service life
counter cleared in “Maintenance Mode 2.”
[Replacement Parts]: “Maintenance Kit Stylus Pro 9500 (Part Code
1058463)”
Counter Clear: (Clear the counters in “Maintenance Mode 2”
(Next page).)
“Waste Ink” Initialization
“Cleaning” Initialization
Table 1-28. Maintenance Call / Error Code List
Error Code Error Content
00000100
Waste ink pad service life Note 1)
(Replacement of the specified part and clearing of the counter are
necessary.)
00000101
Ink supply tube wear Note 2)(This is equivalent to using the printer
beyond the product’s service life, so an error is displayed in
consideration of damage due to ink supply tube wear. Therefore,
when this error occurs, the status of the ink supply tubes should be
checked.)
00010000
PF Motor/ encoder check error.
00010001
PF Motor / Motor out of synch.
00010002
PF Motor / Overcurrent
00010003
PF Motor / In Position Time Out
00010004
CR Motor / Encoder check error
00010005
CR Motor / Motor out of synch.
00010006
CR Motor / Overcurrent
00010007
CR Motor / In Position Time Out
00010008
Servo interrupt WDT time out error
00010009
System interrupt WDT time out error
0001000A
CR home position sensor failure
0001000B
PF home position sensor failure
0001000C
Head slide (SLID) home position sensor failure
0001000E
Cover sensor failure (01)
0001000F
CR Motor / PWM output abnormal
000100010
PF Motor / PWM output abnormal
00020000
NVRAM error
00020001
NVRAM SUM Error
00020002
00020002
00020003
SRAM Check Error
00020004
DRAM Check Error
00020005
Vector Registration Error
00020006
CGRAM Error
00020007
Operation Code Error
00020008
DMA Error
00020009
Flash Memory SUM Error
0002000A
CPU ROM Error
0002000B
Insufficient Internal Memory Error
0002000C
Review Error
10000004
CPU Vector 4 / General improper command issued.
10000006
CPU Vector 6 / Slot improper command
10000009
CPU Vector 9 / CPU address error
1000000A
CPU Vector 10 / DMAC / DTC address error
1000000B
CPU Vector 11 / WDT time out error
Table 1-28. Maintenance Call / Error Code List
Error Code Error Content