Epson Stylus Pro 9500 - Service Related Printer Settings

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 37
1.3.5 Service Related Printer Settings
When the printer is not functioning properly, there are three modes that help
you detect what is wrong and can help you fix the problem. These modes are
“Maintenance Mode”, “Maintenance Mode 2”, and “Self-Diagnostic Mode”. To
enter a mode, press and hold down the appropriate button (described below)
while turning on the printer.
MAINTENANCE MODE
o
Start Button: Turn the Power switch On while pressing the
“Pause” button.
o Setting Item Selection: “Paper Source” Button
o Changing Setting Values: “Setting Value +” or “Setting Value –” Button
o Setting the Set Values: “Enter” Button
o Setting End: Power ON/OFF
o Power-on button: Pause
Note 1): Settings with underlines in the table show default values.
CAUTION
The following explanations regarding control panel service
functions and for service and support purposes only, none
of this information is to be shared with the end user.
Message Item Explanation
HEX DUMP PRINT
This prints out print data transferred
to the printer in hexadecimal form. 16
data items per line are displayed and
in addition, an ASCII character
corresponding to those data is
printed on the right side. If there are
no characters, such as print or control
codes, which correspond to the data,
a “.” (period) is printed. The panel
settings cannot be set while the
printer is in this mode. To end this
function, first stop printing by
operating the Pause button, then turn
the power switch off.
LANGUAGE
ENGLISH
FRENCH
ITALIAN
GERMAN
SPANISH
PORTUGUE
The language displayed in the LCD
screen can be select English, French,
Italian, German, Spanish,
Portuguese.
MW7
A
B
This selects M/W operation in the 720
x 720 dpi mode. A is the operating
mode that reduces banding in Bi-D
printing. B is the Stylus Pro 9000 /
7000 720 dpi x 720 dpi
interchangeable operating mode.