Epson Stylus Pro 9500 - Page 38

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 38
Note 2): During HEX dump execution, the message “HEX MODE” is
displayed.
Note 3): If you are using the Stylus Pro 7000 to print in the single color mode
at 720 x 720 dpi, if banding is prominent, selecting this mode may
possibly reduce banding.
MAINTENANCE MODE 2
o
Start Button:Turn the Power switch On while pressing the following panel
buttons to start.
n “Paper Source Button” + “Cut / Eject Button” + “Paper Feed –
Button”
o Setting Item Selection:“Paper Source” Button
o Changing Setting Values:“Setting Value +” or “Setting Value –” Button
o Setting the Set Values:“Enter” Button
o Setting End:Power ON/OFF
This mode can be roughly divided into the following 3 items.
For each major item, see the following page.
o Counter Display Menu
The items displayed in the Maintenance Mode 2 “Counter Display Menu” are
shown below.
Table 1-29. Maintenance Mode 2 Setting Items
Item Panel Display
Counter Display Menu VIEW COUNTERS MENU
Counter Initialization Menu CLEAR COUNTERS MENU
Adjustment, Setting Menu SERVICE CONFIG MENU
Table 1-30. Counter Display Menu
Item Panel Display Setting Value
Remaining Ink (K) counter
Value Display
INK K 0~4294967295 (Decimal number)
Remaining Ink (C) counter
Value Display
INK C 0~4294967295 (Decimal number)
Remaining Ink (M) counter
Value Display
INK M 0~4294967295 (Decimal number)
Remaining Ink (LC) counter
Value Display
INK LC 0~4294967295 (Decimal number)