Epson Stylus Pro 9500 - Page 40

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 40
o
Adjustment Menu
The items that can be initialized in the Counter Initialization Menu in
Maintenance Mode 2 are shown below.
Table 1-35 List of Adjustment Menu Items
Note 1): Settings with underlines show default values.
Note 2): This sets the desired offset the adjustment value in Bi-D Adjustment
Pattern #3, set by the user. This mode is a function for reducing
irregular color that occurs in the 720 dpi x 720 dpi and 1440 dpi x 720
dpi printing modes due to setting of the desired offset with respect to
the adjustment values for Bi-D adjustment values (Bi-D adjustment
pattern No. #3) for these printing modes. However, since there are
cases where there is no effect even when the desired offset is set in
this function, adequate caution should be exercised when changing
the setting values.
Note 3): This sets whether the sensor which detects the I/C type identifier on
the I/C label will detect it or not.
Note 4): If microbanding, which occurs in the 720 x 360 dpi mode and the 720
x 720 dpi mode actually occurs, this reduction function acts to reduce
banding somewhat when this setting is changed. However, there may
not be any effect even if the setting is set in the desired value by this
function, so exercise caution when changing the setting value.
SELF-DIAGNOSTIC FUNCTION MODE
By turning the Power switch ON while pressing the following panel buttons, the
self-diagnostic mode is started.
o Paper Feed – Button + Cut / Eject Button + Cleaning Button
This mode is used in adjustment work, etc. when carrying out major parts
replacements. For details, see Chapter 5, “Adjustments.”
Table 1-32.
Item Panel Display Setting Value
Right Head Bi-D Offset Setting#1
\(Normal dot) Note 2)
BID OFFSET #1 -4~0~4
Ink Lavel Detection Note 3) DET.ECT INK LABEL
ON
OFF
MW 2 Feed Balance Note 4) MW 7 BALANCE -31~0~+31