Epson Stylus Pro 9500 - Jumper Settings

EPSON Stylus Pro 9500 Revision A
Product Description Control Panel 42
1.3.7 Jumper Settings
The factory default settings for jumper and DIP switch on the Main Board
(C277MAIN) are as follows.
See the following table concerning the display format for each item.
Table 1-33. Jumper Settings
Type Number Setting
Jumper JP1 Shorted
Jumper JP2 Shorted
DIP-SW SWD1 “1” (1-4) OFF (Open)
DIP-SW SWD1 “2” (2-3) OFF (Open)
CAUTION
n The above jumper settings are used for factory settings
only, and should not be changed during servicing. These
jumper settings determine the matching of the firmware,
CPU and ASIC, etc., so if they are inadvertently changed, it
will become impossible to operate the printer.
n When installing the ASP board, the DIP-switch settings
should be changed as shown below. For details
concerning settings, see page 100.
•DIP-Switch Setting DIP-SW1 DIP-SW2
•ASP Board OFF OFF
•When board installed OFF ON
Table 1-34. Printer Status Menu
Display message Meaning
VERSION Shows the firmware version.
INK LEFT-K Shows the amount of remaining ink - Cyan
INK LEFT-M Shows the amount of remaining ink - Magenta
INK LEFT-LC Shows the amount of remaining ink - Light Cyan
INK LEFT-LM Shows the amount of remaining ink - Light Magenta
INK LEFT-Y Shows the amount of remaining ink - Yellow
INK LEFT-K Shows the amount of remaining ink - Black
CUTTER LIFE Shows the remaining useful life of the cutter
TOTAL PRINTS Shows the total number of printed documents
WASTE INK Displays the CR motor life.
CR MOTOR Displays the PF motor life.
PF MOTOR Displays the head unit life.
HEAD UNIT Displays the head unit life.
CLEANER Displays the maintenance kit life.
Table 1-34. Printer Status Menu (continued)
Display message Meaning