Epson Stylus Pro 9500 - Printer Mechanism Disassembly

EPSON Stylus Pro 9500 Revision A
Disassembly & Assembly Disassembly Flow 96
4.2.3 Printer Mechanism Disassembly
This section describes the Printer Mechanism components and the procedure
for disassembly.
4.2.3.1 Replacing the Waste Ink Pads
To keep the printhead clean and maintain quality, the printer drains waste ink
away from the printhead surface and nozzles into the Waste Ink Boxes. Once a
predetermined amount of waste ink has been drained into one of the Waste Ink
Boxes, the printer displays the “Maintenance Call 0100” or “Service Call
00000100” to indicate one of the boxes is full and needs to be replaced.
1. Remove the Maintenance Cover.(See 4.2.1.1)
2. Remove the H Top Cover.(See 4.2.1.2)
3. Remove the L/R Side Covers.(See 4.2.1.3)
4. Remove the Front Cover.(See 4.2.1.4)
5. Remove the Lower Paper Guide. (See 4.2.1.6)
Figure 4-17. L/R Waste Ink Box Positions
CAUTION
This manual only describes the repair and replacement
procedures for parts that can be serviced on site. Therefore,
only perform repair or replace procedures that are
described here. Other service procedures can only be done
at the factory and can become permanent fatal errors if not
done correctly.
CAUTION
When the printer’s useful life counter indicates the ink pads
need to be replaced, the following parts all need to be
replaced at the same time.
n Waste Ink Pads, Left & Right
n Pump Assembly
n Cap Assembly
n Head Cleaner
n F Box, Left & Right
The above mentioned parts are also available as a Kit.
Description: MAINTENANCE KIT
n Parts code: 1058462
Left Waste
Ink Box
Right Waste
Ink Box