Epson Stylus Pro 9900 - Page 117

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
TROUBLE SHOOTING Remedies for Error Messages 117
Confidential
31 INK CARTRIDGE
INK LOW REPLACE INK CARTRIDGE
The ink cartridge is expended. Replace the Ink Cartridge with a new one.
32 BLACK INK MISMATCH
THE TYPE OF BLACK INK IS DIFFERENT
TO CANCEL PRINTING
CANCEL THE PRINT JOB
TO CONTINUE PRINTING
CHANGE THE BLACK INK
The setting of the black ink cartridge differs from the printer
and printer driver.
To continue printing, press the button to change the black ink.
33 INK LOW The ink cartridge is nearly expended. Replacement of the ink cartridge is nearly needed.
34 INK CARTRIDGE ERROR
REPLACE CARTRIDGE
The connection failure between the CSIC and the connection
terminals of the printer.
Remove the Ink Cartridge once, and install it again correctly.
Replace the Ink Cartridge with a new one.
The CSIC has a defect. Replace the Ink Cartridge with a new one.
The dew condensation occurs to the Ink Cartridge. Leave the Ink Cartridge at the room temperature for more than four
hours and install it again.
35 NO MAINTENANCE TANK
INSTALL THE LEFT SIDE MAINTENANCE TANK
NO MAINTENANCE TANK
INSTALL THE RIGHT SIDE MAINTENANCE
TANK
The Maintenance Tank (L or R) is not set in the printer. Install the Maintenance Tank (L or R) correctly.
The maintenance tank (L or R) is not recognized. Remove the Maintenance Tank (L or R) once, and install it again
correctly.
Check the connection between the Maintenance Tank (L or R) and the
Main Board Assy.
Replace the Maintenance Tank (L or R) with a new one. (See P.208)
36 NOT ENOUGH EMPTY SPACE
REPLACE THE LEFT SIDE MAINTENANCE
TANK
The maintenance tank is almost full so the cleaning cannot
be performed.
Replace the Maintenance Tank with a new one.
NOT ENOUGH EMPTY SPACE
REPLACE THE RIGHT SIDE MAINTENANCE
TANK
REPLACE MAINTENANCE TANK SOON
37 MAINTENANCE TANK ERROR
REPLACE THE LEFT SIDE MAINTENANCE
TANK
MAINT TANK ERROR
REPLACE THE RIGHT SIDE MAINTENANCE
TANK
The maintenance tank is not correctly set in the printer. Remove the Maintenance Tank (L or R) once, and install it again
correctly.
The maintenance tank (L or R) is not recognized. Remove the Maintenance Tank (L or R) once, and install it again
correctly.
Check the connection between the Maintenance Tank (L or R) and the
Main Board Assy.
Replace the Maintenance Tank (L or R) with a new one. (See P.208)
No. Message on LCD Description Remedy/Points to be checked