Epson Stylus Pro 9900 - Page 207

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 207
Confidential
4.4.2.5 Front Cover (L/R)
1. Push up the lower part of the Front Cover R to release the three hooks at the
bottom.
2. Release the two hooks on the top, and remove the Front Cover R.
Figure 4-19. Removing the Front Cover (L/R)
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
Front Cover R
Hooks
Hooks