Epson Stylus Pro 9900 - Page 217

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 217
Confidential
4.4.2.13 Roll Cover Assy
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Remove the Spindle Cover R. (p215)
5. Remove the four screws that secure the Mounting Plate.
A) Black, Phillips, Bind machine screw M3x8: three pieces
B) Silver, Phillips, Bind P-tite M3x8: one piece
6. Pull out the guide pin, and remove the brake and the Dumper Cover Holder.
7. Remove the Mounting Plate.
8. Remove the wave washer and the spacer.
Figure 4-31. Removing the Roll Cover Assy (Left side)
B
A
A
A
Brake
Guide pin
Roll Cover Assy
Mounting Plate
Dumper Cover Holder
Wave washer
Spacer
- Left side -