Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 223
Confidential
4.4.2.17 Front Cover Sensor L
1. Remove the IC Cover L and the IC Shaft Cover L. (p206)
2. Remove the Maintenance Tank L. (p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Remove the Rear Cover. (p220)
5. Remove the Ink Tube Guide.
(
Step 8 in “4.4.5.6 Cutter Unit” (P. 257))
NOTE: Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910 only
6. Disconnect the two connectors (CN001, CN301) on the Power Supply Board
Assy.
7. Remove the two screws that secure the PS Board Mounting Plate, and remove the
PS Board Mounting Plate.
A) Silver, Phillips, Bind machine screw M3x6: two pieces
8. Disconnect the connector (CN22) on the Main Board.
9. Release the cables from the seven clamps and the saddle. See Figure 4-40.
Figure 4-39. Removing the PS Board Mounting Plate
Figure 4-40. Releasing the harnesses
A
CN301
CN001
A
- As seen from the rear -
Power Supply Board Assy
PS Board Mounting Plate
Clamp
CN22
- As seen from the rear -
Saddle
Main Board Assy
To Next Page
Loading...
