Epson Stylus Pro 9900 - Page 321

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 321
Confidential
5. Remove the two screws that secure the Main Board Unit.
B) Black, Phillips, Bind S-tite M3x6: two pieces
6. Disconnect the connector from the Take-up Reel Motor, and remove the Main
Board Unit.
7. Remove the C-Ring.
8. Remove the four screws that secure the Motor Mounting Plate, and remove the
Motor Mounting Plate.
C) Black, Phillips, Bind S-tite M4x8: four pieces
9. Remove the two gears from the Motor Mounting Plate.
10. Remove the two screws that secure the Take-up Reel Motor, and remove the Take-
up Reel Motor.
D) Black, Phillips, Bind S-tite with S.W & P.W. M3x6: two pieces
Figure 4-184. Removing the Main Board Unit
Figure 4-185. Removing the Motor Mounting Plate
Figure 4-186. Removing the Take-up Reel Motor
Main Board Unit
Connector
B
B
Take-up Reel Motor
C
Motor Mounting Plate
C-Ring
Take-up Reel Motor
Gear
Gear
D
Motor Mounting Plate