Epson Stylus Pro 9900 - Page 342

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 342
Confidential
4.4.8.15 Cooling Fan 1
1. Remove the Color Measurement Device. (p325)
2. Remove the Mounter. (p327)
3. Remove the Front Cover. (p331)
4. Remove the Left Cover. (p329)
5. Remove the four screws that secure the Cooling Fan 1 mounting plate, and remove
the Cooling Fan 1 mounting plate.
A) Silver, Phillips, Bind P-tite M3x8: four pieces
6. Disconnect the relay connector, and release the harness from the clamp.
7. Remove the four screws that secure the Cooling Fan 1, and remove the Cooling
Fan 1.
B) Silver, Phillips, Bind S-tite with S.W & P.W. M3x12 & nut: four pairs
Figure 4-217. Removing the Cooling Fan 1 mounting plate
Figure 4-218. Removing the Cooling Fan 1
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p351) and perform
specified adjustments after replacing the Cooling Fan 1.
<Adjustment Item>
1. Counter Clear (FAN)
A
Relay connector
Cooling Fan 1
Cooling Fan 1
mounting plate
Clamps
B
Cooling Fan 1
Cooling Fan 1
mounting plate