Epson Stylus Pro 9900 - Page 437

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908 Revision I
ADJUSTMENT Tests 437
Confidential
 Paper holder check
1. Select Paper holder check.
2. If the following screen appears, click on the [OK] button.
Figure 5-105. [Paper holder check] Screen
3. While the following screen is displayed, check the status of Paper Pressing
Plate. Confirm the whole Paper Pressing Plate is touching the backing without any gap.
If any abnormality is found, check the following.
Figure 5-106. Confirmation Screen
Figure 5-107. Check Point
Symptom Remedy
Paper Pressing Plate does
not operate.
Check the installation status of Paper Pressing Plate. (p. 349)
Check the status of Paper Pressing Motor, and if any abnormality
found, correct it.
Check the status of Paper Pressing Encoder, and if any abnormality
found, correct it.
Check the Paper Pressing Plate Sensor, and if any abnormality
found, correct it.
Install the backing if not installed.
No gap in between