Epson Stylus Pro GS6000 - Page 163

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 163
Confidential
4.4.11.3 MAINTENANCE ASSY
1. Unlock the Carriage and move it to the center. (p83)
2. Remove the MAINTENANCE COVER ASSY (right only). (p91)
3. Remove the MAINTE COVER, B (right only). (p92)
4. Remove the four screws and remove the fixing plate.
A) Silver, Phillips, Cup M3x6: four pieces
Figure 4-137. Removing the fixing plate
5. Pull off the two tubes with a joint at their ends from the PUMP ASSYs to the right.
Figure 4-138. Disconnecting the tubes
A
Fixing plate
As seen from the front
As seen from the front
1
2
PUMP ASSYs