Epson Stylus Pro GS6000 - Page 165

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 165
Confidential
4.4.11.4 FLUSHING BOX ASSY
1. Unlock the Carriage and move it to the center. (p83)
2. Remove the MAINTENANCE COVER ASSY (right only). (p91)
3. Remove the screw and remove the FLUSHING BOX ASSY.
A) Silver, Phillips, Pan with S.W & P.W M3x8: one piece
Figure 4-140. Removing the FLUSHING BOX ASSY
4.4.11.5 CLEANER HEAD
1. Unlock the Carriage and move it to the center. (p83)
2. Remove the MAINTENANCE COVER ASSY (right only). (p91)
3. Pry the two tips to disengage the hooks, and pull up the CLEANER HEAD to
remove it from the WIPER ASSY.
Figure 4-141. Removing the CLEANER HEAD
A
FLUSHING BOX ASSY
As seen from the top
C A U T I O N
 Never touch the tip of the CLEANER HEAD with bare fingers
as oil on your fingers may damage the print head.
 If too much ink is piling around the CLEANER HEAD, it is
recommended to replace the WIPER ASSY also.
As seen from the front
CLEANER HEAD
Pry here
WIPER ASSY
CLEANER HEAD
WIPER ASSY