Epson Stylus Pro GS6000 - Page 166

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 166
Confidential
4.4.11.6 WIPER ASSY
1. Unlock the Carriage and move it to the center. (p83)
2. Remove the TOP COVER (right only). (p85)
3. Remove the PANEL COVER (right only). (p86)
4. Remove the SIDE COVER (right only). (p89)
5. Remove the IH COVER (right only). (p90)
6. Remove the REAR PAPER GUIDE. (p96)
7. Remove the SPINDLE GUIDE COVER. (p97)
8. Remove the FLUSHING BOX ASSY. (p165)
9. Disconnect the relay connector.
Figure 4-142. Disconnecting the relay connector
10. Remove the screw and remove the WIPER ASSY drawing out the cable from the
hole beneath.
A) Silver, Phillips, Cup M3x6: one piece
Figure 4-143. Removing the WIPER ASSY
Relay connector
As seen from the rear
SUB_B BOARD
ASSY
Cable of WIPER
ASSY
As seen from the top
WIPER ASSY
Screw A