Epson Stylus Scan 2000 Quick Start

Attach the paper
and document
supports
Make sure you check the system and location
requirements and follow all the safety
instructions in your User’s Guide. Plug the printer into a properly
grounded outlet. If you need help in setting up your printer, see
“Solving Problems” in your User’s Guide.
CAUTION
Remove any tape and packing materials.
Make sure you have all the parts. If any parts are missing, contact EPSON
as described in your User’s Guide . You’ll also need a cable to connect the
printer to your computer.
start
h
ere
Unpack your
EPSON Stylus Scan
Plug in
your
EPSON
Stylus
Scan
3
4
2
5
6
Install the ink
cartridges
Install the ink cartridges (continued)
1. Lower the tray.
3. Press the power button.
The lights come on and the
print head moves.
6. Insert the color ink
cartridge as shown.
Then press the clamp down
until it snaps into place.
The ink out light goes off.
4. Lift up the clamp.
2. Open the front cover.
5. Unwrap the ink cartridges. Then
pull off only the yellow part of
the tape seal on top. Don’t pull
off the blue portion or remove
the clear seal on the bottom of
the cartridge.
9. Insert the black
cartridge as
shown.
Then press
the clamp
down until it
snaps into
place.
7. Press the cleaning
button. The print head
moves to the left so you
can install the black ink
cartridge.
8. Lift up the clamp.
10. Press the cleaning
button to begin charging the
ink delivery system. Then
close the front cover.
Charging takes about 2 minutes. The power light flashes and the printer
makes various sounds. Don’t turn off the printer yet. Wait until the power
light stops flashing and stays on.
1. Slide out the
edge guide.
When you release the buttons, the nozzle check page starts to print. This is
what it should look like:
If it doesn’t look right, you may need to run a print head cleaning cycle. See
your User’s Guide for instructions. If it doesn’t print, see “Solving Problems” in
your User’s Guide.
2. Slide out the
tray extensions.
3. Place the stack of
paper against the
right side of the
feeder.
1. Turn off the printer.
2. Hold down the load/eject button.
4. Make sure the paper
fits under the arrow mark
inside the edge guide.
Slide the guide against
the paper.
oovveerr
➱
Test your
EPSON Stylus Scan
Load paper
1
uunnffoolldd
turn
here
document
support
paper
support
User’s
Guide
software
printer
protection
sheet
ink cartridges
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets in your eyes, flush them
immediately with water. Keep ink cartridges out of the reach of children.
WARNING
Don’t open the clamps to remove a cartridge except to
replace it with a new one. Once you remove a cartridge,
you can’t reuse it, even if it contains ink. You must install both cartridges and
leave them installed for all types of printing. To avoid damaging the printer,
never move the print head by hand.
CAUTION
3. Press the power
button.
Continue at the top of the next column.
paper support
document
support

Epson Stylus Scan 2000 Specifications

General

Brand	Epson
Model	Stylus Scan 2000
Category	All in One Printer
Language	English