Figure 5-9. Screw Position
NOTE: Make sure to loosen this screw. Otherwise, the printhead angle will
not change even if the adjustment lever moves.
5. Look very closely at the black/magenta lines in the bottom pattern and
move the adjustment lever to center the magenta lines between the black
lines. The figure below shows how to move the lever to correct a
misaligned pattern.
Figure 5-10. Lever Operation
6. After changing the position of the adjust lever, select Print - Angular Adj.
again from the Production Menu.
7. Verify the pattern on the printout again.
8. Repeat this process until the combination pattern of black/magenta is
correct.
9. After completing the adjustment, tighten the printhead screw, and
reassemble the Stylus Scan.
Printhead securing
screw
To move this down
Move the lever to
the rear
Correct condition = vertical spacing
is even
To move this up
Move the lever to
the front
Adjustment lever
To Next Page
Loading...
