Epson StylusPro 10000 - Removing the HEAD_SLIDE Sensor ASSY; Removing the PG Motor; Drive Gear

EPSON Stylus Pro 10000/10000CF Revision A
Disassembly & assembly Disassembly Flow
1
77
4.2.3.18 Removing the HEAD_SLIDE Sensor ASSY
1. Remove the R Side Cover as described in “R Side Cover Removal 124.
2. Remove the Rear Cover as described in “Rear Cover Removal 126.
3. Disconnect the harness for the HEAD_SLIDE Sensor ASSY from its connector CN52
on the C362DRV board and take the harness out from the hole in the R Side Frame.
Figure 4-150.
4. Remove the two screws (CP(W) M1.2x8) securing the HEAD_SLIDE Sensor ASSY
and remove the HEAD_SLIDE Sensor ASSY.
5. Release the harness for the HEAD_SLIDE Sensor ASSY from the cable clamps.
4.2.3.19 Removing the PG Motor / Drive Gear
1. Remove the R Side Cover as described in “R Side Cover Removal 124.
2. Remove the Rear Cover as described in “Rear Cover Removal 126.
3. Marking the PG motor fixing position.
Figure 4-151.
4. Disconnect the harness for the PG motor from its connector CN15 on the C362DRV
board and take the harness out from the hole in the R Side Frame.
Figure 4-152.
Screw
Head Slide Sensor
Marking the fixing
position
Harness
(connected to CN15
on the C362DRV
board)
PG motor
Cable clump