44
5.3.4.11 Head LR (Head gap) adjustment
Correct the head to head gap.Print the test pattern with Uni-D mode and make sure the print
quality by referencing the Figure 5-69, "" then input the correction value
Following
t
able showing adjustment menu. Figure 5-67, "" showing menu sequence and
Following figure showing print pattern.
Figure 5-67.
Table 5-15.
Item Description
Gap 240. V1 .C 240 CPS with cyan ink.
Gap240.V1.M
240 CPS with magenta ink.
Gap 240 . V1 .LC 240 CPS with light cyan ink
Gap240.V1.LM
240 CPS with light magenta ink.
Gap240.V1.Y 240CPSwithyellowink.
Gap300.V1.C 300CPSwithcyanink.
Gap300.V1M 300 CPS with magenta ink.
Gap 300 . V1 .LC 300 CPS with light cyan ink.
Gap300.V1.LM 300 CPS with light magenta ink.
Gap 300 . V1 Y 300 CPS with yellow ink.
Item
Item
Item
Item
Item
Item
SelecType
SelecType
SelecType
SelecType
SelecType
SelecType
Enter
Start the print with "Enter" key.
Printing Pattern
Gap 240.V1.C 0
Gap 240.V1.M 0
Gap 240.V1.LC 0
Gap 240.V1.LM 0
Gap 240.V1.Y 0
Gap 300.V2.C 0
1
34
2
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
Adjustable with "Paper Feed +/-
" key at unit of 1/2880 inch.
To Next Page
Loading...
