Epson StylusPro 10000 - 1.6 SelecType Settings

EPSON Stylus Pro 10000/10000CF Revision B
Product Description
S
e
lecType Settings 42
Notes*:Only when PG setting = WIDE, 20th character is "H" on LCD.
1.6 SelecType Settings
o Entering SelecType mode
To access the operating Panel settings, press the SelecType button while the printer is not
printing. The printer enters the SelecType mode and cannot print.
o Using SelecType mode
1. Repeatedly press the SelecType button to view the SelecType menus which appear in
the order shown below.
2. Press the Item button to select the choice shown in the LCD display.
3. Press the SelecType button to view the options for that Item.
4. Press the “+” button or “-” button to view the available values for an option.
5. Press the Enter button to record the current option or to execute the operation shown in
the display.
INK LOW
When total dots fired = 90%, cartridge enters near-end
condition. Remaining ink = A1 at 100% duty
MAINTENANCE REQ. nnnn
Printer requires maintenance - see “Maintenance
Request” on page 49
PRINTING *
Processing print data.
PAPER OUT
• No paper loaded
• End of roll paper (printer stops feeding)
• End of sheet paper (when paper feeds to eject
position, put hand under the sheet and press Cut/
Eject to release)
Table 1-27. Operating Panel Messages (continued)
Display Message Meaning
Table 1-28. SelecType Menus
Display Message For details
PRINTER SETTING MENU
Printer Setting Menu
TEST PRINT MENU
Test Print Menu
PRINTER STATUS MENU
Printer Status Menu
PAPER CONFIG. MENU
Paper Configuration Settings
CUTTER REPLACE MENU
Cutter Replacement Menu
HEAD ALIGNMENT MENU
Head Alignment Menu